Foil Fast

innovative system to connect the foil to the board, with titanium screws

The new foil connection system that changes the rules of the game.

Foilfast uses the innovative Upside Down system
which allows you to position and tighten the board/foil connection screws in a few seconds, effortlessly and with maximum precision:
the finbox nut is integral with the bolt and therefore it is sufficient to screw the special upper nut by hand
to the bolt protruding from the surface of the box;
for safety, just a light tightening with the supplied thin wrench and everything is ready to get into the water.

CUSTOM CONSTRUCTION

Each FoilFast is handcrafted according to your specifications, to perfectly adapt to your Board/Foil system,
given that there is nothing standard on the market

the upper Nut adapts to both conical and flat hole plates: just flip it over.

Custom construction in aerospace grade 5 titanium which guarantees
extreme resistance, lightness and zero corrosion, even in marine environments

the ultra-compact tightening wrench is designed to accompany you everywhere:
it easily slips into the wetsuit key pocket or a pocket of your impact vest,
so you can adjust the position of the foil at any time, even directly on the beach or in the water.

Made by Riders for Riders

Less time on land and more time in the water, with maximum reliability and zero compromises.
Forget broken threads, seized screws, unusable torx or allen keys, forget the useless waste of time searching for nuts in the box and using wrenches that damage the Mast:
FoilFast completely eliminates this problem and every session starts without stress.

Tech Spec

Material
Grade 5 Titanium (Ti-6Al-4V) – light, strong and stainless; ideal for marine environments and intensive use
Quick tightening system
easy positioning, assembly in seconds, thanks to the guided centering design
Universal
A CUSTOM Construction for every board/foil system on the market
Screw length:
from 20mm to 90mm with CUSTOM CUT
Thread:
M6 - M8
Tensile strength // Young's Modulus (Elasticity)
Titanium GR5 ˜ 950 Mpa // 110 Gpa
Tightening wrench:
10mm
The Kit includes :
4 complete titanium FoilFast
2 x 10 mm tightening wrenches
Screw bag / organizer
Quick user manual
Set FoilFast Prices
Titanium GR5
from 0 to 50mm   69€
from 51 to 90mm    89€

Create your Custom FoilFast

               

All measurements are in mm (1 cm = 10 mm)

Screw Diameter:
Choose M8 or M6 based on the system on your foil

choose Countersunk (1) or Flat (2) depending on the system present on your Foil


Fin Box
measure the height from the upper rail of the box to the surface of the board
it is recommended to use a tape measure, resting the metal tab on the upper rail



mm

Plate Thickness
measure the thickness of the foil mounting plate
it is recommended to use a caliper to measure at the screw holes;
check if the thickness is the same at both holes, otherwise use the higher value


mm

Additional Thicknesses
measure any additional components that add thickness
(Washers, Shims, FoilDrive Battery Case, etc.)
it is recommended to use a caliper to measure at the thickest point;


mm
Your Board
Your Mast
Total Input Lenght:
0 mm
Total FoilFast Lenght:
0 mm

Send Order